Removal
System Cover
Identify the system cover highlighted in blue.
Using a flat head or a Phillips screwdriver, rotate the lock counter clockwise.
Lift the latch till the system cover slides back.
Hold the cover on both sides, and lift the cover away from the system.
Airshroud
Internal PERC riser
Identify the internal PERC riser highlighted in blue.
Open the cable guiding latch for easy access.
Lower the plunger.
Hold the blue touch points and lift the internal PERC riser out of the system.
Turn the internal riser so that the PERC card is facing up.
Press the cable connector and disconnect the PERC cable from the backplane.
Control panel -Left
Identify the control panel highlighted in blue
Using the blue touchpoints, slide the backplane cover back and lift to remove.
Disconnect the control panel cable from the system board connector.
Unoute the control panel cable from the side wall of the system.
Remove the screws that secure the cable cover.
Remove the cable cover securing the Left Control panel Cables
Remove the screws that connect the control panel to the system.
Holding by the sides, remove the left control panel assembly away from the system.
Install
Control panel -Left
Identify the control panel location highlighted in blue
Route the control panel cable through the side wall of the system.
Align the left control panel assembly with the slot and slide into place
Connect the control panel cable to the system board connector
Install the cable cover to secure the Left Control panel cables
Install the screws that secure the cable cover.
Install the screws that secure the control panel assembly to the system
Lower the backplace cover into the slot and slide until it snaps into place.
Internal PERC riser
Identify the internal PERC riser location highlighted in blue.
Connect the cable to the internal PERC card.
Holding the blue touch points, align the slot on the internal PERC riser to the guide on the system board.
Insert the internal riser card’s edge connector firmly into the system board connector until the riser is fully seated.
Lift the plunger to lock the riser in place.
Close the cable guiding latch .
Airshroud
System Cover
Identify the system cover location highlighted in blue.
Align the tabs on the system cover with the guide slots on the system.
Push the system cover latch down.
Using a flat head or Phillips screwdriver, rotate the lock clockwise.